MBC and accessories
Manual Boost Controller is a device that allows to simply and safely increase the turbo boost thus increasing engine power. This is the bleed type valve without a spring and a ball (often have a tendency to jam, arbitrary changes in recharge under the influence of differences in temperature, and working on higher gears may cause a dangerous overboost). The installation of this valve is simple - side spouts are plugged in between the actuator and the compressor shell or inlet manifold, while the third connector is not connected. As it can be can sees in the picture below, MBC is very neatly and solidly constructed. It also has a lock to prevent accidental deregulation. On the other auctions we offer vacuum lines, which are necessary during the installation of the valve. This is not a Chinese product – MBC are made in European Union!!! ..
16.83€
Ex Tax:14.02€
This device makes it possible to manually change and set boost pressure – increase the engine power of your vehicle !!! !!!! Brand new model !!!!-Ceramic ball of bigger diameter increases the device’s reliability, - 2 springs (increased range of regulation). Operation: Set the desired boost pressure (e.g. 0.5bar). Until there is such a pressure in the system (on the intake side), the valve will be tightly closed. After exceeding the set pressure threshold, the valve will open. Such a mode of operation results in an immediate boost. The vehicle’s speed increases, as the driver has the full boost at his or her disposal from the very beginning – even with slightly closed throttle valve. While taking advantage of the MBC, it is also recommended to install a boost gauge to check the settings after each modification. The pressure type valves are connected along the pressure flow line and attached to the WG. The valve also incorporates he vent channel...
26.59€
Ex Tax:22.15€
Showing 1 to 0 of 9 (0 Pages)